Full Mitre Connector

The Full Mitre Connector is designed for corner application when the landing is offset from the staircase. It is also used in any form of joint where a mitre is required as it has a outstanding range of angles from 80 – 180°.

To use a Full Mitre Connector, follow these steps:

1. Measure and Cut:
   Measure the angles where the two pieces of wood or handrail will meet, and then cut them at a 45-degree angle to create a mitered joint.
2. Align the Pieces:
   Position the two mitered ends together, aligning them perfectly to form a seamless joint.
3. Apply Adhesive:
   Apply a suitable wood adhesive or glue to the mitered edges to ensure a strong bond.
4. Insert the Full Mitre Connector:
   Place the Connector inside the joint, ensuring that it fits snugly into the pre-cut slots or holes in both pieces.
5. Tighten the Connector:
   Use a screwdriver or wrench to tighten the connector, pulling the two pieces tightly together and securing the joint.
6. Check the Joint:
   Inspect the mitered joint to make sure it is flush and secure. Wipe away any excess adhesive.

By following these steps, you can successfully use a Full Mitre Connector to create a strong, precise mitered joint between two pieces of wood or handrail.

• Size 8 x 135mm
• Housing size 25mmø x 20mm
• For mitre joints between 80-180°
• 5mm drive bit for tensioning
• Zinc